During the startup every day, let the machine run for two minutes. When stopping for more than one day, please relax the setting handle to prevent damage to related parts. The knife die shall be placed in the middle of the cutting surface. Wash the machine once a day before leaving work, and keep the electrical parts clean at any time, and check whether the screws are loose. The lubrication system in the body should be checked regularly, the oil filter in the tank must be cleaned once a month, the oil pipe and joints must be locked without oil leakage, and the cutting machine should not wear the oil pipe in order to avoid damage. When removing the oil pipe, the pad should be placed at the bottom of the seat, so that the seat is lowered to the pad, to prevent a large amount of circulating oil leakage. Before removing the oil pressure system components, it must be noted that the motor should stop completely without pressure.
When working, the cutting knife of the automatic cutting machine should be placed in the center of the upper pressure plate as far as possible, so as not to cause the mechanical unilateral wear and affect its service life. The cutter setting must first relax the set hand wheel, so that the setting rod contacts the cutting point control switch, otherwise the cutter setting switch cannot produce the setting action. Replace a new cutter, if the height is different, it should be reset according to the setting method. Cutting machine cutting action should pay attention to both hands please leave the cutting knife or cutting board, it is strictly prohibited to use the hand to help the knife mold to cut to avoid danger. If the operator temporarily leaves the operating position, always close the motor switch to avoid damage to the machine. Cutting cutter shall avoid overload to damage the machine and reduce service life. When operating the cutter, care should be taken to avoid the serious consequences caused by small errors.
Post time: Apr-10-2024