What problems may be encountered in the mechanical swing arm cutting machine in the process of work?
Mechanical swing arm cutting machine in the daily production process can not be no problems, for general faults and abnormal problems we how to deal with, the following to simply understand the next a few small problems!
When the newly installed machine is started, press the handle switch plate if the pressure is not depressed, please check whether the rotation direction of the motor is correct, adjust and check the cutting machine.
If there is abnormal sound of the machine and abnormal conditions such as automatic pressure of the upper pressure plate, please immediately turn off the power supply and stop using, and notify the maintenance personnel. You can continue your work only after checking it correctly
If the pull-down handle switch moves twice on the press plate, try to fine-tune the wood brake below to lock it tightly.
After using the hand wheel to adjust the pressure plate, lock the hand wheel lock hoop to avoid the automatic sinking of the hand wheel rotation during the use.
The newly installed machine can be padded with rubber, cardboard, cloth and other materials under the bottom four corners. Make the machine operate more stable and reduce the noise.
About the causes and solutions of the pressure instability of the cutting press machine
Production safety is not only the personal life safety, and the mechanical safety, in the production process will inevitably appear the problem of this or another, cutting machine is light industry use the most ordinary kind of machinery, but many companies often encounter cutting machine pressure instability problem, what is the cause of this problem?
Product cutting is not in place, product and waste tear constantly situation; will also appear indirect uneven cutting.
Since we know the reason for the unstable pressure of the cutting machine, then what are the specific solutions? Here’s a brief understanding of its solution!
1. Abnormal depth time system: causing inaccurate timing or unstable power supply of the solenoid valve; the time system relay needs to be replaced.
2. Abnormal travel switch: sometimes clever and sometimes ineffective; need to replace the travel switch.
3. Loose of relay and other related electrical parts; cause poor contact, cause the reversing valve not in place; tighten the connection end.
4. Oil pump wear: causing insufficient oil supply; the oil pump needs to be replaced.
5. Leak in the cylinder: causing pressure relief; the cylinder needs to be replaced.
6. Long die line: beyond the range of equipment capability; the matching equipment with die line shall be used.
7. The hydraulic oil is too dirty and the oil filter element is blocked: the oil supply is insufficient; the filter element needs to be cleaned or replaced.
8, solenoid valve spool card, poor: lead to insufficient cylinder supply; need to clean the solenoid valve spool.
Post time: Feb-12-2025