When the boot every day, it is best to allow the machine to run for two minutes without cutting. When the machine is stopped for more than a day, please set the handle to relax in order to prevent damage to the relevant parts. In operation, the die should be placed in the middle of the cutting section. The machine should be cleaned once every day before work and keep the electrical parts clean at any time. Should regularly check whether the normal operation of the body lubrication system, oil tank oil filter must be cleaned once a month, tubing, fittings should be lock can not have leakage phenomenon, the use of cutting machine under the condition of the pipe friction, to avoid breakage. When the oil pipe should be placed at the bottom of the seat pad block, so that the pressure drop to the pad block and a large number of anti circulation oil leakage. It is important to note that the motor should be completely stopped without pressure to remove the hydraulic system parts.
When working, the cutting knife is placed in the central position of the upper pressing plate, so as to avoid the unilateral abrasion of the machine and the service life of the cutter. The knife set must be set to relax the handwheel, set the pole contact to the cutting point control switch, otherwise the knife set cannot produce the set operation switch to ON. The replacement of the new cutter, such as height should be set according to the method, re set. The cutting machine cutting action should pay attention to both hands please leave the knife or chopping board, it is forbidden to support the knife mold by hand and cutting to avoid danger. If the operator temporarily from the operating position, be sure to turn off the motor switch, so as not to cause improper operation of others injured and injured. Avoid the use of overload cutting machine so as not to damage the machine and reduce the service life, usually operating work matters cutting machine must pay attention to avoid the serious consequences caused by small mistakes.
Post time: Apr-12-2022