The machine ready position, three-phase power supply anti-wear hydraulic oil (46#) machine is placed before the rubber pad machine foot pad good backup, and fix the machine foot screws. Install two brackets. Cover with inner six angle screws knife to open the machine in the middle, anti-wear hydr...
Industrial production in the industry, people often see the installation and use of cutting machine, but such equipment used in the process and there will be a lot of problems, one of which is cutting machine without pressure, so what is the reason of this phenomenon it, here we work on this for ...
Clicking press cutting machine is a kind of cutting machine, in the industry is very suitable for non metal material cutting small area. Then, using the clicking press machine we should pay attention to what the problem?
1, set the swing arm cutting machine when you can put the handwheel to the s...
When the boot every day, it is best to allow the machine to run for two minutes without cutting. When the machine is stopped for more than a day, please set the handle to relax in order to prevent damage to the relevant parts. In operation, the die should be placed in the middle of the cutting se...
As following:
1, measuring equipment (diameter micrometer, dial gauge, pneumatic instrument) to decide whether to regularly check the project?
2, measuring equipment regularly check, regular exchange is decided?
3, regular, irregular exchange of measuring equipment, whether the implementation of ...
1, the hydraulic oil tank is not enough, the oil pump suction air or oil filter is blocked by dirt will cause the oil pump oil shortage, resulting in the oil bubbles discharged from the impact of the blade.
The solution is to check the amount of oil, to prevent inhalation of air and cleaning filt...
In the mechanical parts manufacturing process, plastic machine vibration and shape factors such as cutter or knife wheel from gangrene, chip separation, making the parts surface obtained by friends, always leave the uneven fine by small spacing and peak valley composition, the uneven surface in r...
In the past five years, Chinese cutting machine manufacturers have built rapidly and the prices are getting lower and lower, so the transformation and upgrading of enterprises is imminent, and those who do not upgrade will die first. The direction of upgrading is mainly to automation, intelligenc...