Welcome to our websites!
News
-
The reason and solution of cutting material in automatic cutting press machine
1, the hardness of the pad is not enough due to the improvement of work efficiency, the number of the pad cut more, the replacement speed of the pad faster. Some customers use low-hardness pads to save costs. The pad does not have enough strength to offset the large cutting force, so that the mat...Read more -
Maintenance focus of the four column cutting press machine
As the most widely used cutting machine, the precision four-column cutting press machine needs to be effectively maintained during its use. Today, we will understand the maintenance focus of the precision four-pillar cutting machine. 1. Run for 3~5 minutes for heating machine, especially when the...Read more -
Reason and solution of abnormal sound of cutting press machine
With the continuous progress of production technology, the cutting machine has encountered fewer and fewer faults, and in general, there are few abnormal ring situations. Today we are going to analyze the causes and solutions of the abnormal noise. Solution: add hydraulic oil; clean the hydraulic...Read more -
Safety operation procedure for precision four-column cutting press machine
1. Objective: In order to better maintain the equipment and the safe use, to ensure the safe operation of the precision four-column cutting machine. 2. Scope of application: precision four-column cutting machine and other hydraulic cutting machine. 3. Safe operation procedure: 1. The operator of ...Read more -
Maintenance focus of precision four-pillar cutting press machine
As the most widely used cutting machine, the precision four-column cutting machine needs to be effectively maintained during its use. Today, we will understand the maintenance focus of the precision four-pillar cutting machine. 1. Run for 3~5 minutes for heating machine, especially when the tempe...Read more -
The matters needing attention of precise four-column cutting press machine precautions
1, please add enough amount of 46 # wear-resistant hydraulic oil (hm 46); 2. Check the positive and reverse version of the motor to avoid the motor reversal; 3. It is strictly prohibited to use precision four-column cutting machine to overload to avoid machine damage; 4. When cutting operations, ...Read more -
How should the automatic cutting press machine be repaired?
Automatic cutting press machine is a kind of mechanical equipment, after a period of use may appear some faults, these faults need to be timely maintenance, otherwise it will affect the production efficiency. The following paper analyzes the common faults of the fully automatic cutting machine, a...Read more -
Fully automatic cutting press machine needs to pay attention to the matters
1. Long-term overpressure use. It can also cause insufficient pressure on the cutter. 2. Large benches use knife molds for a long time and deviate off the center. 3. After the front and rear punching knife or about long-term local use, can be fixed for a long time. 4. The oil pump is the power pr...Read more -
The reason of the fully automatic cutting press machine does not stop pressed
Automatic cutting machine is a modern cutting equipment, which can efficiently complete the material cutting, cutting and other work. When using the fully automatic cutting machine, sometimes the pressure will not stop, affecting the normal work of the equipment. The reasons of the automatic cutt...Read more -
What are the hazards of the density deviation of the automatic cutting press machine?
1. Reduction of product quality: the density deviation of the automatic cutting machine will lead to the uneven density of the cut products, too dense or too loose in some areas, resulting in the decline of product quality. For example, for the textile industry, if the density of the fabric is no...Read more -
How should the cutting press machine do not work to handle?
A cutting machine is a kind of equipment, usually used for cutting paper, cloth, plastic film and other materials. It is an integral part of modern factories and production lines. Although the cutters may be maintained and maintained, sometimes they may suddenly stop working or malfunction. When ...Read more -
The part of fault treatment of hydraulic control system of the fully automatic cutting press machine
1. The control signal of the cutting machine is not input into the system A. Check whether the oil pressure of the cutting machine system is normal, and judge the working condition of the oil pressure pump and the overflow valve. B. Check whether the execution element is stuck. C. Check whether t...Read more