For the low speed crawling caused by the uneven friction of the guide element in the hydraulic cylinder of the automatic cutting machine, it is recommended to use metal as the guide support. The coefficient should be small, for the thickness of the support ring, the size tolerance and thickness uniformity must be strictly controlled.
Equipped with two brackets. Open the cover plate between the machine with a hexagonal shear and use anti-wear hydraulic oil. After the machine is energized, (three fire wires and one ground wire) are on, turn on the power switch and the oil pump working switch, and then immediately turn off the power switch; the staff faces to see if the motor blade is clockwise or counterclockwise. Rotate clockwise to turn the whiskers clockwise. If the fan blade of the motor rotates counterclockwise, the position of any fire line can be adjusted in the case of power failure.
At this point to see the cutting depth, otherwise it will damage the mold. Press the wire cutting button on the top of the machine with both hands and pull out the tray.
Automatic cutting machine, to see whether the material is cut. If there is no cut, fine tune the cut depth, adjust one scale, try cutting to see the effect; if not, adjust another scale and try cutting; if there is a little cut, adjust half scale and then cut again. Only after it has just cut, adjust it half the scale. Remember to only trim the cutting depth.
Post time: Jun-28-2024