Cupping machine is the inevitable type of machinery for light industry, the use and production of cutting machine in China has been quite perfect, cutting machine but for the understanding of the cutting machine believe there are still a lot of not very understand, after all, simple operation know one is enough, the following is a simple understanding of the grinding principle of the cutting machine!
In fact, the world’s machinery is the same, such as the car is the same, if a car used for a long time without the necessary maintenance and rest, then it is necessary to be scrapped in advance, a slightly better car, as long as the maintenance of good and timely can exercise 500,000 kilometers without major failure.
The development of cutting work needs internal and external refining, the first need is to change the concept, establish a long-term development concept and formulate a feasible development policy. And constantly improve the company’s management level, improve the management efficiency, reasonably optimize the department structure, prevent human capital and the waste, optimize the company’s internal competition mechanism, improve the essence of the work of workers, to the surface, to promote the work brand construction.
The individual work of each mill can be regarded as a knife with a negative front corner, while the whole grinding wheel can be seen
cutting machine
A milling cutter with multiple JJ teeth, but the cutting teeth are composed of many scattered sharp edges with different shapes, different cutting edge openings and very irregular distribution.
Fault description: After the cutting machine has set the cutter mode, the machine does not rise after pressing and the machine does not cut off protection. When you encounter this fault, you are advised to troubleshoothe fault according to the following methods:
1. First of all, replace or replace the relay in the cutting electromechanical box. Three relays are used on the Honggang cutting machine, which control the rise, fall and setting respectively;
2. If step 1 fails to be solved, check whether the rising height value is set as too small. If the number is normal, the time controller may fail, and it is necessary to replace or change the time controller;
3, the most complex is the last reason, a link of the common failure is the solenoid valve failure, then need professional guidance to solve;
What is the function of using the solenoid valve on the cutting machine
Solenoid valve is the use of the electromagnetic control of industrial equipment, is used to control the fluid of the automatic basic components, belongs to the actuator, is not limited to hydraulic pressure. Used in the industrial control system to adjust the medium direction, flow, speed and other parameters. The solenoid valve can cooperate with different circuits to achieve the expected control, and the accuracy and flexibility of the control can be guaranteed. There are many kinds of solenoid valves, different solenoid valves in the control system of different positions play a role, the most commonly used is the one-way valve, safety valve, direction control valve, pressure control valve and so on.
Solenoid valve has a closed cavity, open a hole in different locations, each hole connect different tubing, the cavity in the middle is the piston, two sides are two electromagnet, which magnet coil power valve body will be attracted to which side, through the control of the valve body to open or close different oil hole, and oil hole is often open, hydraulic oil will enter different pipes, and then through the oil pressure to push the oil cylinder of piston, piston and drive piston rod, piston rod drive mechanical device. This controls the mechanical motion by controlling the flow off of the electromagnet.
Post time: Jul-28-2024