The machine ready position, three-phase power supply anti-wear hydraulic oil (46#) machine is placed before the rubber pad machine foot pad good backup, and fix the machine foot screws. Install two brackets. Cover with inner six angle screws knife to open the machine in the middle, anti-wear hydraulic oil. The machine electrical connection (three FireWire, a ground wire) after connection, open the power switch of the machine, open the pump switch, turn off the power switch immediately; staff face motor fan, see motor fan clockwise or counterclockwise rotation, clockwise rotation must. If the motor fan blade is counterclockwise rotation, in the case of power failure, arbitrary adjustment of the position of a firewire. The machine will adjust the cutting depth for preheating, closed set switch, will set down the handle moves to the middle position, hands on cutting machine action button, will more than a dozen preheating. Put the plate on the work table (which can support the white board, to put on the pallet), nylon plate (plate size and the working table is as large as), situated in the middle of the plate; the knife mold plate placed between the blade down. Place the splint is pushed into the machine working table, plate edge and the edge of the table is homogeneous phase machine. Release the set handle (counter clockwise) and open the switch. This machine descends to press the cutter, plate, plate. Set the handle to move up and down a few, to prevent the setting down. Tighten the set handle (clockwise), turn off the switch. From the plate, the material (waste material) on the bottom (edge of knife mold to material, then push plate) the work table and the work table, the plate edge edge of qi. Looking at the cutting depth must be otherwise it will damage the knife mold. Hands on the above machine for cutting button, cutting out after the pallets, see whether the material is cut down. If there is no cutting, trimming cutting depth, a scale effect is not again cut; cut, then try a scale cut; and a bit not cut, then cut again half scale. Only to just cut, and then adjust the half scale can be. You can only trim cutting depth. Warning: you may not have a hand into the table in the staff at any time!
Post time: Apr-12-2022